Geocoding from GPS data happens automatically as you load images and matching track logs into a HoudahGeo project. When HoudahGeo is able to match an image’s timestamp to a time span covered by the track logs it will compute the image’s location.
Click the Geocode Using GPS Data toolbar button to adjust options of the geocoding algorithm and to start automatic geocoding over.
Kickstart automatic geocoding only for the currently selected images. Settings made below nonetheless apply to the whole project.
Enable automatic geocoding from GPS track logs. HoudahGeo will match up image timestamps to timestamps in the GPS track log and thus compute image locations.
Number of minutes by which to extend the search for tracks matching a given photo. A photo is considered to match up with a track if it falls within the track's time span or within the specified number of minutes before the beginning or after the end of that time span. The default value is 5 minutes.
GPS devices may start new tracks when turned on or after losing GPS signal. Strictly speaking we cannot geocode a photo that falls between two tracks. HoudahGeo however decides to merge two tracks if the time elapsed between the first track's end and the other track's beginning is less than the specified number of minutes. The default value is 30 minutes.
HoudahGeo determines the location where a photo was taken by matching it up with two track points: one preceding and one following the time the photo was taken. If the closest point's timestamp is more than the specified number of minutes before or after the photo was taken, HoudahGeo considers there is no match and does not geocode the photo. The default value of 0 disables this check.
Enable automatic geocoding from GPS waypoints. This applies to images for which track log geocoding yielded no result. For each image HoudahGeo will try to locate a waypoint that is close in time and match the image to that waypoint’s location.