A video action overrides properties found in the Video Properties panel.
Below is a screen-shot of a video action on a screen recording clip. The colored action rectangle starts at time 1.5 (1.5 seconds), and continues until time 2s (2 seconds):

It is best to think of a Video Action as a marker in your presentation; a place where properties change.
Everything to the left of the Video Action is the before
state.
Everything to the right of the Video Action is the after
state.
Everything inside the Video Action is transition, or ramp
up/down
.
To edit the properties of a Video action, you must move the Scrubber to the beginning or end of the Video Action.
If you move the Scrubber to the right of the video action, then
change a video property, you will affect the after
state of the
Action. When the action completes, the value will be what you
configure. You can edit the after
state by moving the Scrubber
anywhere to the right of the clip, as long as the Scrubber is before
any other Video Action.
If you move the Scrubber to the left of the video action, then
change a video property, you will affect the before
state of
the Action. When the action begins, the value will be what you
configure. You can edit the before
state by moving the Scrubber
anywhere to the left of the clip, as long as the Scrubber is after any
other Video Action.
Using the above screen-shot, we have a Video Action starting at time 1.5, and finishing at time 2.
If you move the Scrubber to time 2 (as shown) and set the Scale of the Video Properties to 50%, then play the presentation, the screencast will reduce in size from 100% to 50% for 0.5 seconds of your presentation (starting at 1.5 seconds in). Thereafter, the Scale stays at 50%, until the Scrubber encounters another Video Action. Thus, a Video Action changes the state of your properties (the scale, etc.), while defining the duration of the change.